Plastics pipes and fittings - Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusion (ISO 11414:2009, IDT)
Status:
Valid
Buy this standard
StandardSwedish standard
·
SS-ISO 11414:2020
Plastics pipes and fittings - Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusion (ISO 11414:2009, IDT)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions
This International Standard specifies a method for preparing butt-fusion-jointed test piece assemblies
between polyethylene (PE) pipes and spigot-ended fittings.
This International Standard specifies the assembly parameters involved, such as the ambient
temperature, joint geometry and fusion parameters, taking into account the service condition limits
specified in the relevant product standards, as well as the type of pipe to be used.
This International Standard is intended to enable the effect of site assembly variables on joint
performance to be determined. The fusion-jointing procedures and parameters used in the field can
differ from those in this International Standard, depending on the manufacturer's written procedures
and/or local standards.
NOTE The assembly and fusion-jointing technique specified in this International Standard is applicable
whatever the polyethylene resin employed, provided it is used in accordance with ISO/TR 11647[1]. Deviations
from the fusion cycle specified, in order to demonstrate joint performance, can be considered in accordance with
the notes in Annexes A and B.
Plastics pipes and fittings - Preparation of polyethylene (PE) pipe/pipe or pipe/fitting test piece assemblies by butt fusion (ISO 11414:2009, IDT)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions