Spherical plain bearings - Part 1: Radial spherical plain bearings (ISO 12240-1:1998, IDT)
Status:
Valid
Buy this standard
StandardSwedish standard
·
SS-ISO 12240-1:2020
Spherical plain bearings - Part 1: Radial spherical plain bearings (ISO 12240-1:1998, IDT)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions
This part of ISO 12240 specifies dimension series, tolerances and radial internal clearances for radial
spherical plain bearings.
The dimensions and tolerances specified in this part of ISO 12240 have been selected to permit the
design of radial spherical plain bearings using a wide choice of sliding material combinations.
The specified tolerance values apply to finished, radial spherical plain bearings before any coating,
plating, ring splitting or ring fracturing.
In the case of surface treated radial spherical plain bearings, there may be slight deviations from the
specified tolerance values.
Radial spherical plain bearings need not conform to the designs illustrated but compliance is required
as regards the dimensions, tolerances and radial internal clearances specified.
NOTE — Spherical plain bearings for airframe applications are not covered by this part of ISO 12240.
Spherical plain bearings - Part 1: Radial spherical plain bearings (ISO 12240-1:1998, IDT)
Subscribe on standards with our subscription service. When you use our service you can be assured the latest editions and easy access.
Read more about SIS Subscriptions