Standard Svensk standard · SS-EN ISO 75-1:2004

Plast - Bestämning av formbeständighet under belastning - Del 1: Allmän provningsmetod (ISO 75-1:2004)

Status: Upphävd

· Ersätts av: SS-EN ISO 75-1:2013
Köp denna standard

Standard Svensk standard · SS-EN ISO 75-1:2004

Plast - Bestämning av formbeständighet under belastning - Del 1: Allmän provningsmetod (ISO 75-1:2004)
Prenumerera på standarden - Läs mer Dölj
Pris: 875 SEK
standard ikon pdf

PDF

Pris: 875 SEK
standard ikon

Papper

Fler alternativ Färre alternativ
Provläs denna standard
Omfattning
1.1 ISO 75 specifies methods for the determination of the temperature of deflection under load (flexural stress under three-point loading) of plastics. Different types of test specimen and different constant loads are defined to suit different types of material.
1.2 This part of ISO 75 gives a general test method, part 2 gives specific requirements for plastics (including filled plastics and fibre-reinforced plastics in which the fibre length, prior to processing, is up to 7,5 mm) and ebonite while part 3 gives specific requirements for high-strength thermosetting laminates and long-fibre-reinforced
plastics in which the fibre length is greater than 7,5 mm.
1.3 The methods specified are suitable for assessing the relative behaviour of different types of material at elevated temperature under load at a specified rate of temperature increase. The results obtained do not necessarily represent maximum applicable temperatures, because in practice essential factors such as time, loading conditions and nominal surface stress may differ from the test conditions. True comparability of data can
only be achieved for materials having the same room-temperature flexural modulus.
1.4 The methods specify preferred dimensions for the test specimens. Tests which are carried out on specimens of different dimensions, or on specimens which are prepared under different conditions, may produce different
results. Consequently, when repeatable data are required, sample preparation conditions and test variables should be carefully controlled and recorded.
1.5 Data obtained using the test methods described may not be used to predict actual end-use performance.
The data are not intended for design analysis or predicting the endurance of materials at elevated temperatures.
1.6 For part 2, two test specimen positions are allowed. However, the flatwise position is the preferred and recommended one, while testing in the edgewise position is described as optional only.

Ämnesområden

Plast Allmänt (83.080.01)


Köp denna standard

Standard Svensk standard · SS-EN ISO 75-1:2004

Plast - Bestämning av formbeständighet under belastning - Del 1: Allmän provningsmetod (ISO 75-1:2004)
Prenumerera på standarden - Läs mer Dölj
Pris: 875 SEK
standard ikon pdf

PDF

Pris: 875 SEK
standard ikon

Papper

Fler alternativ Färre alternativ

Produktinformation

Språk: Engelska

Framtagen av: Plast, SIS/TK 156

Internationell titel: Plastics - Determination of temperature of deflection under load - Part 1: General test method (ISO 75-1:2004)

Artikelnummer: STD-36328

Utgåva: 2

Fastställd: 2004-06-04

Antal sidor: 15

Ersätter: SS-EN ISO 75-1

Ersätts av: SS-EN ISO 75-1:2013